Dating guitars by pot codes netherlands dating com
Sometimes a date is stamped or hand-written on the butt of the neck.Vintage reissue instruments have the date on the butt end of the neck like the originals.How to date and identify your Fender instruments using serial numbers and production date stamps.No one likes it when you forget their birthday and neither does your Fender. For most of Fender’s production history they have applied serial numbers and production dates that can help you determine their production date (within a few years’ margin, at least).For example, let’s take a Stratocaster with the serial number 279515 and the code 22384109B.Starting with the letter B, this is the same neck width code Fender has been using since 1962.Determining the date can also be important from a collector’s perspective, since the pre-1966 vintage Fender guitars are generally considered the most valuable.
Only about half the guitars still carry any intelligible information here.Neck dating can be useful in finding the approximate age of your guitar.Since the neck is only a component of the guitar, it could have been produced a number of years before the actual instrument was assembled, hence the date on the neck is not necessarily the production date of the whole guitar.It is important to remember that Fender serial numbers are NOT conclusively chronological. Back in the day, Fender made their serial number plates in big batches and the assembler simply grabbed a decal or more from the crate and slapped it on the guitar. To get as close as possible to determining the age of your Fender, make sure to check all dates on both body, neck and pots.The locations of the serial numbers and dates change from model to model and in some cases they have simply been omitted.
1954-1959: Same as above, only the format is M-YY, leaving out the day. March 1962 to 1965: Dark blue or red ink stamps below the truss rod adjustment at the neck butt. The “XX” does not refer to the day; it is a code for the neck type (e.g. The “W” stands for neck width: “A” is the narrower, “B” is normal width, and “C” wider and “D”, though rarely seen, is the widest.